General Wire I-95-D Basic Unit: Combines Units I-95-A and I-95-C
General Wire I-95-D Basic Unit: Combines Units I-95-A and I-95-C The I-95-D Basic Unit Including six 7.5R8 sections, five 15R10 sections, CC Cable Carrier, SCC Cable Carrier, R-8CS Cutter Set, R-10CS Cutter Set, Tool Box, 1/3 hp Motor with Reverse Switch, 10 ft. Power Cord, Ground Fault Interrupter, and Leather Gloves. General Wire I-95-D Basic Unit Features: With a 1/3 hp motor, the I-95 clears lines from roof-top to basement, including kitchen, bath and laundry drains. Here's a sectional cable machine that drives 7/8" and 5/8" sections or even 5/16" cables for small drain work. You can switch from 7/8" to 5/8" and back by repositioning the chuck cone. No adapter required. Attach a small drum to the back of the machine to drive smaller cables. The I-95-D gives you more than versatility. It gives you power and convenience. The motor is a 1/3 hp capacitor type, so it delivers plenty of torque to the cables. Yet, as soon as you lift the drive handle, the cable stops rotating, so there's no additional torque build up. You also use the drive handle to carry the machine. And when the I-95 is in position on the job, its four point base gives it rock-solid stability. A cutter holder is attached to the back so your cutting heads are always with the machine. A ground fault circuit interrupter is standard equipment General Wire I-95 Basic Unit Specifications: • Weight: 39 lbs. (18 kg) • Dimensions: 14" deep x 12" wide x 23" high. (35.5 cm x 30.5 cm x 58.4 cm) • Motor: 1/3 hp with forward-off-reverse switch, ten foot power cord, and ground fault circuit interrupter. • Adjustable Chucks: Has two sets of notches; one for 5/8" cables and one for 7/8" cables. Switch from one diameter to the other in seconds. • Leather Gloves: Double palm, for hand protection when guiding cable. • Cables: "T" slot couplings slide together to lock and uncouple with a pin key. 7.5R8 - 7-1/2 ft. x 5/8" (2.3m x 15.6 mm) for 1-1/4" through 3" lines up to 125 ft long; 15R10 or 15R10P with Proflex inner core " 15 ft. x 7/8" for 2" " 4" lines up to 150 ft. long. • Cutter set for 7/8" cables: Spear Head, 2" U-Cutter, 3" U-Cutter, Hook Auger and Retrieving Tool. • Cutter set for 5/8" cables: Arrow Head, Boring Gimlet, 1-1/2" U-Cutter and Retrieving Tool.
